,

Затверджувач EPH 161


Compare

для епоксидної смоли L 20
90 хвилинний

35.0  / кг

Product Price

Hardener for Epoxy Resin L and L 20, EP Gel coat colourless and Mould Resin P
Contains no formaldehyde and no paraformaldehyde

Epoxy Resin L 
Processing time: 90 minutes
Mixing ratio:
100 : 25
 parts by weight of resin to hardener
100 : 29
 parts by volume of resin to hardener
Curing time: 24 h at room temperature, followed by hot curing for: approx. 10 h at 60 °C
Max. heat distortion temperature after annealing: 120 °C

Laminate structures for vehicle construction in combination with this product and epoxy resin L are approved by the TÜV-Süd. Process instructions/TÜV-Report (unfortunately only in German)

Epoxy Resin L 20 
The combination of L 20 and Hardener EPH 161 yields a low-viscosity laminating resin that exhibits superior impregnating and wetting properties to glass, aramid, and carbon fibres. In conjunction with L 20, hardener EPH 161 results in a long service life for the resin compound with very high mechanical and dynamic strengths and perfect curing in both thick (> 2 cm) and thin (1,5 mm) laminates. Before they can obtain the specified mechanical properties, the laminates must be post-cured for about fifteen hours at 60 °C after their initial cold-curing period.

The system L 20 + EPH 161 is approved for the construction of gliders.
Processing time: 90 minutes
Mixing ratio: 
100 : 25
 parts by weight of resin to hardener
100 : 29
 parts by volume of resin to hardener
Curing time: 24 h at room temperature, followed by post-curing: for 15 h at 60 °C

Gel coat colourless
Processing time: 90 minutes
Mixing ratio: 100 : 24 parts by weight EP Gel coat : Hardener EPH 161
Curing time: 24 h at room temperature, afterwards hot curing approx. 10 h/60 °C (recommended, but not necessary).
Max. heat distorsion temperature after annealing: approx. 120 °C

Mould resin P
Processing time: 90 minutes
Mixing ratio: 100 : 17 parts by weight Mould Resin P : Hardener EPH 161
Gelling time: approx. 4 h
Curing time: 24 h at roomtemperature, afterwards hot curing: approx. 15 h/60 °C

Please order resin L and L 20, gel coatcolourless and mould resin P separately

Technical Data Sheet Epoxy resin L 20 and hardener

You may also like…

Select your currency
EUR Euro